|
Episode Electronics 2 In x 6 Out IR Repeater Kit with Power Supply
Kit Includes:
(1) Episode® Electronics 2 In x 6 Out IR Repeater (IR2X6)
(1) Episode® Electronics 12 Volt 1 Amp Power Supply (PS-12DC-1A)
Universal compatibility
The IR2X6 works with virtually all A/V components and remote controls.
2 Input and 6 Outputs
Accommodates two IR sensors and up to six IR flashers. With selectable routing for two of the IR flasher outputs, the IR2X6 can be used for two zone systems.
1/8" jack and screw terminal inputs
We know flexibility is important. That's why we give you a choice of input types, 1/8" (3.5mm) jack and removable screw terminals.
Flexible placement and installation
We engineered the Episode IR2X6 to be small and rugged. And we gave it steel mounting ears with keyhole slots for quick, easy installation.
3 Year Warranty
The Episode IR2X6's durable external design is mated with an internal layout and circuit board components that will provide years of trouble free operation.
Specifications:
5"W x 2-3/8"D x 1-1/4"H
Comparable Products:
Niles MSU250
For the IR 2X6 IR Repeater installation manual Click Here.
|
| Still have a question?? Email us at support@snapav.com |
3-Year Limited Warranty
Episode® IR Products have a 3-Year Limited Warranty. This warranty includes parts and labor repairs on all components found to be defective in material or workmanship under normal conditions of use. This warranty shall not apply to products which have been abused, modified or disassembled. Products to be repaired under this warranty must be returned to SnapAV or a designated service center with prior notification and an assigned return authorization number (RA).
|
Troubleshooting Guide - IR Flashers
Problem: Cable box responds erratically or skips channels. Cable box remote works only when close to IR receiver. Extra delay between channel or volume changes.
|
SnapAV
Products Affected:
|
RSM-3660
IR1x4
IRF-1
IRF-2
PS-12DC-1A |
Solution: SnapAV flashers are very strong and the output signal that may be overpowering some components.
Place the flasher on a nearby surface. Under a shelf or on the opposite door if in a cabinet or closet. Masking tape can be used under the flasher to help minimize the effect. Depending on the component a piece of electrical tape with a pinhole will also work well.
This same symptom may be also caused by a “Double flash”. A IR receiver is triggered by the same signal a millisecond apart. This is mostly caused by the flasher of a nearby component or a reflection off a light colored surface. This will confuse some component IR receivers and cause them to temporarily “freeze” or lock up.
This can be remedied by using the flasher cover included with the IRF-1 and IRF-2. Some components have a very large area of IR receiver that will not be covered by the IRF covers included. Black electrical Tape or a similar covering will block any stray IR.
Check the component manuals for the IR receiver locations and size.
Product Development Team – SnapAV. 12/2009 DMCM
|
