Fixed-fit end caps are shaped for one specific extrusion profile, helping close the end of a linear lighting run and limit light from escaping. Universal end caps are available for compatible extrusion configurations, such as in-wall, 45-degree, square 45-degree, or economy profiles, so select the style that matches the installed extrusion.

Match the end cap to the extrusion’s profile and configuration, such as a standard, in-wall, 45-degree, square 45-degree, or economy design. Use a fixed-color or universal style when it corresponds to the tape light and extrusion setup, and confirm that the end cap is shaped for that specific extrusion before installation.

End caps plug the open end of the extrusion around a tape light run, helping prevent light from escaping through the end. Their shaped fit also gives the installation a clean, finished appearance by closing the extrusion neatly.

Choose an end cap shaped for the specific linear lighting extrusion, including in-wall, angled, square, or other profile designs, so it seats properly at the end of the run. Install it after the tape light and extrusion are in place to close the profile, help prevent light from escaping, and provide a finished appearance.