Wired linear lighting controls use physical low-voltage, Ethernet, or control-bus connections, while wireless controls use Zigbee communication to adjust dimming, color, or color temperature without a dedicated control cable to each module. DALI provides digital control over a lighting bus, while DMX uses universes and decoders to translate control signals for LED tape, so the right approach depends on the lighting protocol, wiring plan, and system integration requirements.

Choose a constant-voltage power supply that matches the linear light and controller, with 24V DC common across the listed systems and some three- and five-channel modules supporting either 12V DC or 24V DC. Size the supply for the connected load and run length, and check whether the control method requires additional hardware, such as a separate 24V supply and DALI line power device for DALI gateways.

Channel counts correspond to the separate LED outputs a controller can dim or adjust: single-color lighting typically uses one channel, tunable white uses two or three, RGB uses three, RGBW uses four, and RGBTW uses five. Choose a controller with enough channels for the strip’s color or white-tuning configuration, while some multi-channel modules can also operate several independent single-color or warm-dimming runs.

When integrating linear lighting controls with an existing automation system, confirm the system supports the selected control method, such as Zigbee, DALI, or DMX, and plan for compatible gateways, drivers, power supplies, wiring, and channel requirements. For future expansion, leave capacity for additional lighting zones, choose controllers that support the needed LED types and tuning functions, and allow accessible locations for commissioning and service.